Solutions

Detection of the inner wall of magnetic rings

Machine vision

Inspect the inner wall of the magnetic ring for cracks, defects and dirt.

View Details

Detection of the inner hole of the engine cylinder block

Machine vision

The inner hole of the engine cylinder block is inspected, with the depth-to-diameter ratio greater than 1:1 (inner diameter 18mm, depth 68.4mm). The depth of field of the common 360° inner wall inspection lens cannot meet the depth inspection requirements

View Details

Detection of the inner cavity of the coupling

Machine vision

The inner wall defect detection of the coupling, with an inner diameter of 25mm and a detection depth of approximately 43mm, has a depth-to-diameter ratio greater than 1:1. The ordinary 360° inner wall inspection lens depth of field cannot meet the detect

View Details

Detection of the bottle mouth and inner wall of the bottle body

Machine vision

The inner diameter of the bottle mouth is 19.5mm, the height of the bottle body is 135mm, and the inner diameter of the bottle body is approximately 90mm. The inner wall needs to be inspected. Due to the variation in the inner diameter of the bottle mouth

View Details

Character detection on yogurt bottle bodies

Machine vision

Detect and recognize some characters on the label of the outer side wall of the bottle.

View Details

Defect detection on the outer side surface of bottle caps

Machine vision

Generally, catadioptric lenses for inspecting the outer wall can be matched with 5-megapixel, 2/3-inch cameras. However, the customer requires higher inspection accuracy and needs lenses that can be matched with higher-pixel 1-inch cameras.

View Details

Detection of characters on the body of medicine bottles

Machine vision

The outer diameter of the bottle is 16mm, and the height of the label on the outer side wall is 20mm. It is necessary to detect and recognize the characters on the label of the outer side wall. When the aperture is at its minimum, the ordinary refractive

View Details

Defect detection on the bottom surface of wine bottles

Machine vision

The inner diameter of the bottle mouth is 19.5mm, the height of the bottle body is 135mm, and the inner diameter of the bottle bottom is approximately 90mm. It is necessary to conduct defect detection on the inner bottom surface of the bottle. Due to the

View Details

Airbag detonator inspection

Machine vision

At present, the client side still uses manual detection methods, which have the following problems: high labor intensity, low efficiency, quality cannot be guaranteed, and no data is retained.

View Details